5GAL PAIL MACH TOOL SUMP&SYSTEM CLEANER

MSTFWHMXXT-5G MFG #: WHMXXT-5G

$213.26 / EA

Master STAGES™ Whamex XT™ is a low foam, safe, fast-acting, concentrated formula that will save machine cleaning downtime while removing the oily residues, scums and insoluble soap deposits that reduce coolant life. Whamex XT™ is made for cleaning out machine tool sumps and larger systems, coolant supply lines and coolant recycling equipment. Whamex XT™ is compatible with most waste treatment (including ultrafiltration) and will not degrade TRIM® metalworking fluids when used as directed.

QTY

Add to List

Application
Item Features

General-purpose garden sprayer, scrub out the chips, sludge, and any other residues from all interior, exterior, tool changer areas including high-pressure sumps and filter canisters

A very specialized formula that draws on Master Chemical's knowledge of coolant formulation and many years of hands-on experience in machine cleanouts
Quickly breaks down and lifts off insoluble scum deposits hidden in lines and difficult to reach areas - getting rid of these residues is one of the best ways to extend coolant life in your system
Very hard water tolerant allowing it to be effective in raw water or used coolant
Environmental approvals are simplified because Whamex XT™ contains no nitrites, phosphates, barium, phenols, or butyl cellusolve; this formula has very low V.O.C. content and no SARA 313 reportable ingredients
When used as directed below, this product is compatible with TRIM® brand synthetic, semisynthetic, and soluble oil coolants, as well as most competitive coolants
Will remove heavy soils from machines without affecting paints, coatings, seals, hoses, or skirting, and it wont leave a slippery residue
Short-term corrosion inhibitors prevent flash rusting of machine surfaces and ways
PREFERRED METHOD FOR CLEANING MACHINE TOOLS AND CENTRAL SYSTEMS: Add 1%-3% Whamex XT™ into the machine sump and run machine as normal for at least 24 hours or more for best results, if the machine runs high pressure through-the-tool for significant amounts of time, the cleaner may cause some foam, keep a defoamer, such as Master STAGES™ DF1 or TRIM® TC 239, available during this process
After the Whamex XT™ has circulated for at least 24 hours, pump out the sump and remove all chips, sludge, residue and swarf. Remember to clean out overflow areas and flumes
Spray down the machine with a 10%-15% Whamex XT™ and water solution using
10 at 2% Working Solution, 10.5 at 5% Working Solution pH range
>200 deg F flash point
12 Months shelf life